IKEA RIGGA clothes rack, white: interactive 3D assembly guide

All 9 steps

1. 1Screw two shoe bars to a foot

   Stand a foot on its castors. Hold a shoe bar with a thread in its ends to it and turn a connector (10084881) by hand through the hole in the foot into the bar, until its head sits right down in the hole. Do the same with the second threaded bar: 2 connectors. The two plain bars wait for the next step.

2. 2Stand it on the foot and add the plain bars

   Tip the foot over onto its side on the rug, so the two bars point straight up. Push the two plain shoe bars into the slots in the foot between them.

3. 3Lay the other foot on the bars

   Lay the second foot on the top ends of the four bars, the same way round as the first, so the ends go into its holes and slots.

4. 4Screw the bars to the second foot common mistake

   Turn a connector (10084881) by hand down through each of the two holes in the top foot into the threaded bars under it, until its head sits right down in the hole: 2 connectors. Common mistake: Each connector’s round head must go right down into its hole, as the manual’s pictures on pages 3 and 5 show. One that goes in at a slant, or sits on the edge of the hole, stands out and never takes hold of the bar’s thread: take it out, line it up with the bar, and turn it in again until its head is down in the hole.

5. 5Lay it on its castors and tighten

   Tip the base back down onto its four castors. Tighten all four connectors with the hex key (108490), until their heads sit flush in the feet.

6. 6Put the uprights over their sockets

   Lower an upright over the socket on each foot, its holes towards the other upright, until its notched end sits astride the foot’s tube.

7. 7Bolt the uprights to the feet

   Push a bolt (10003302) through the square hole at the foot of each upright and its socket from outside, and turn a sleeve nut (106498) onto it from inside with the hex key until it is tight.

8. 8Screw the rail onto the uprights

   Push a plastic insert (128998) into the top of each upright. Lay the rail on them and screw a connector (10084881) down through each end of the rail into the upright with the hex key: 2 connectors.

9. 9Set the rail’s height

   Press in the button on an upright, slide its inner tube up or down, and let the button click into another hole; do the same on the other side, to the same hole, so the rail is level. There are six heights, from 126 to 175 cm.

Parts and hardware checklist

Tools you need

None: it goes together by hand.

Questions

Safety

The manual warns that the rack can tip over: move it gently, and keep its load within 35 kg.

About this guide

The steps, the part numbers, the counts and the order come from IKEA's assembly manual AA-712786-6 (2021-08-25). The outer size, 111 × 51 × 126–175 cm, is IKEA's published size. The length, depth, the six heights and the shoe bars’ height are IKEA’s, the hex key’s size a spare-parts seller’s; the tubes, the castors and where the holes are, are read off the manual’s drawings and IKEA’s photos, so they are close, not measured. The 3D runs faster than real hands do.

IKEA gives the rack a maximum load of 35 kg in all.

The manufacturer's instructions are on IKEA's product page (PDF). If something here differs from the manual in your box, follow the manual.

The 3D models, drawings and text are our own. IKEA and RIGGA are named only to say which product this guide is for.