Step by step BEKVÄMstep stool
Step4/7
Hardware in0/13
Parts in0/8
Open IKEA PDF ↗
Put on the second side framestep 4 of 7 · manual page 5
Common mistakeLeaving a screw head standing outthe rail is not pulled tight against the leg, so the stool wobbles

iFlatpack.com is an independent platform creating original 3D procedural instructions. We are not affiliated with, endorsed by, or sponsored by Inter IKEA Systems B.V. or any other brand mentioned. All product names and part numbers are used strictly for identification and compatibility purposes.

Step 4 of 7 · IKEA manual page 5

BEKVÄM step stool step 4 of 7: Put on the second side frame

Push the second side frame onto the other ends of the four rails and onto the step’s dowel. Fix it with 4 long screws through its legs, each turned until its head sits flush in its hole.

Tools: Hex key (100092, in the box)

Common mistake: leaving a screw head standing out. Turn each long screw until its head sits flush in its hole, as the close-ups in the manual show. A head left standing out has not pulled the rail tight against the leg: the joint moves, the stool wobbles, and the screw works loose. The switch in the player shows what goes wrong.

All 7 steps

  1. 1Fix the lower rails to a side frame common mistake
  2. 2Fix the top rails
  3. 3Slide in the lower step
  4. 4Put on the second side frame common mistake
  5. 5Screw the steps on from below
  6. 6Press it down evenly
  7. 7Give every screw a last turn

Parts and hardware checklist

2×Side frameabout 48×38.1×3.4 cm
1×Lower railabout 34.3×5×2.2 cm
1×Front railabout 34.3×5×2.2 cm
2×Top railabout 31.7×5×2.2 cm
1×Lower stepabout 38×16.6×2.2 cm
1×Top stepabout 41×25×2 cm
8×Long screw#100215
3×Short screw#105111
2×Dowel#101350 · 8 × 30 mm
1×Hex key#100092
1×Hex key handle#121030

Tools you need

None: it goes together by hand.

Questions

Do I need any tools to build the BEKVÄM step stool?

No. The hex key and its plastic handle come in the box, and the manual uses nothing else.

How much weight does the BEKVÄM step stool hold?

IKEA gives its maximum load as 100 kg.

Which way round do the rails go?

Their ends are cut at a slight slant, to match the side frames, which lean in towards the top: fit each rail so its ends lie flat against the legs. The front rail’s warning label faces out.

Why does my step stool wobble?

A screw is not tight, or it was tightened while the stool stood unevenly. Stand it on a flat floor, press down on the top step so all four legs touch, and give the 8 long screws a last turn, as the manual’s last two pages show.

Should I tighten the screws again later?

Yes: IKEA says to re-tighten the screws when necessary. The hex key’s handle makes it quicker.

Safety

A step stool that wobbles can throw you off. Tighten every screw before you use it, check them again now and then, and stand it on a flat, firm floor. IKEA gives its maximum load as 100 kg.

About this guide

The steps, the part numbers, the counts and the order come from IKEA's assembly manual AA-444158-13 (2026-05-13). The outer size, 43 × 39 × 50 cm, is IKEA's published size. The frames’ lean, the rails, the steps and the hole positions are read off the drawings and IKEA’s photos, so they are close, not measured. The 3D runs faster than real hands do.

IKEA gives its maximum load as 100 kg.

The manufacturer's instructions are on IKEA's product page (PDF). If something here differs from the manual in your box, follow the manual.

The 3D models, drawings and text are our own. IKEA and BEKVÄM are named only to say which product this guide is for.