iFlatpack.com is an independent platform creating original 3D procedural instructions. We are not affiliated with, endorsed by, or sponsored by Inter IKEA Systems B.V. or any other brand mentioned. All product names and part numbers are used strictly for identification and compatibility purposes.

Step 13 of 13 · IKEA manual page 15

POÄNG armchair step 13 of 13: Put on the cushion

Hook the cushion’s flap over the top of the backrest, onto the strip of hooks, and lay the cushion down over the slats and the seat. Done.

1× Cushion

Tools: none, just your hands

All 13 steps

Parts and hardware checklist

2×	Backrest side	about 67.5×24.9×2.4 cm
1×	Slat	about 52.5×5.6×3.2 cm
3×	Slat	about 52.5×4.4×3.2 cm
1×	Seat	about 56.6×52.5×8.7 cm
2×	Seat bar	about 52.7×9×1.8 cm
2×	Side frame	about 80.4×60.8×5 cm
1×	Front brace	about 58×4×2.8 cm
1×	Back brace	about 58×3.6×3 cm
1×	Cushion	about 77.8×68.9×52 cm
8×	Screw	`#119046` · M5 × 13 mm
6×	Screw	`#120925`
2×	Pin	`#123786`
2×	Washer	`#102319`
2×	Bolt	`#146654`
4×	Barrel nut	`#100514` · M6 thread
4×	Bolt	`#122606`
1×	Hex key	`#100001`

Tools you need

Flat screwdriver · Turns each barrel nut in its brace, by the slot in its end, until its threaded hole faces the bolt.

Questions

What tools do I need for the POÄNG armchair?

The hex key comes in the box. The manual also shows a flat screwdriver, to turn the barrel nuts in the braces until they face their bolts.

Which screws go where?

The eight screws 119046 hold the slats; the six screws 120925 hold the seat. Of the long bolts, the two shorter ones (146654) go through the armrests and the four longer ones (122606) into the braces. The manual shows each with a close-up and warns against the other.

Which way round do the slats go?

Each slat is bowed: its middle goes towards the back, so the backrest gives a little under your back. The slat with the strip of hooks goes second from the top; the cushion’s flap holds on to it.

How much weight does the POÄNG hold?

IKEA says it has been tested for people weighing up to 110 kg.

Should I tighten the bolts again later?

Yes: the manual shows the six bolts being tightened again with the hex key, the one through each armrest and the two in each side frame’s braces.

Safety

Check the bolts now and then and tighten them again: a loose armrest or brace makes the chair wobble. IKEA says the chair has been tested for people weighing up to 110 kg.

About this guide

The steps, the part numbers, the counts and the order come from IKEA's assembly manual AA-2615392-2 (2025). The outer size, 68 × 82 × 100 cm, is IKEA's published size. The curves of the bent parts, the slats, the braces and the hole positions are read off the drawings and IKEA’s photos, so they are close, not measured. The 3D runs faster than real hands do.

IKEA says the chair has been tested for people weighing up to 110 kg.

The manufacturer's instructions are on IKEA's product page (PDF). If something here differs from the manual in your box, follow the manual.

The 3D models, drawings and text are our own. IKEA and POÄNG are named only to say which product this guide is for.