Part number
10046278 Back holder, bottom
Pushed down over the top edge of the back plinth and the foot of the back, so they hold together.
Quick size & thread spec
- Size
- 26.3 × 17.5 mm · 1 × ¹¹⁄₁₆″
- Tool
- by hand
1:1 On-Screen Screw & Part Sizer
1:1 SCALEHold your physical screw or dowel flat against the screen to verify length and thread diameter.
Length: 26.3 mm Ø Diameter: 17.5 mm
- In the box
- 2 with the IKEA PAX wardrobe frame
Lost or broke part 10046278?
Ask IKEA for spare part 10046278, naming the product it is for. IKEA’s UK site says small spare parts such as screws, knobs or plugs can be ordered free online; elsewhere, look under Customer service, then Spare parts, on your country’s IKEA site, or ask at a store’s customer service desk.
Where it goes
- IKEA PAX wardrobe frame 2 in the box, in one step
Commonly used in
IKEA furniture series that use this part:
- PAX
Fitting it
Fit it as the manual shows, in the steps listed above.
Taking it out
To take it out, follow those steps the other way round.
Other parts on iFlatpack
10042543Back holder, top 38 × 18 × 31 mm · IKEA PAX100644Connecting sleeve M4 × 25 mm · IKEA PAX10095544Cabinet holder 42 × 14 mm · IKEA IVAR10120505Stop 34.3 × 16.4 × 19.5 mm · IKEA PAX120298Shelf holder 15 × 16 × 12 mm · IKEA LACK130884Fitting 10 × 13.5 mm · IKEA IDÅSEN130886Snap pin 4.5 × 15 mm · IKEA IDÅSEN133203Cable grommet 174 × 30 × 38 mm · IKEA BESTÅ133209Cable grommet lid 170 × 20 × 5.5 mm · IKEA BESTÅ144348H-profile 224 × 16 × 3 mm · IKEA BESTÅ144567Cable grommet 220 × 20 × 30 mm · IKEA BESTÅ199840Power unit IKEA IDÅSEN
Questions about part 10046278
What size is part 10046278?
Part 10046278 is a back holder, bottom: 26.3 × 17.5 mm (1 × ¹¹⁄₁₆″).
What tool fits part 10046278?
Part 10046278 goes in by hand: no tool is needed.
Which furniture models use part 10046278?
Part 10046278 is used in IKEA PAX.