iFlatpack.com is an independent platform creating original 3D procedural instructions. We are not affiliated with, endorsed by, or sponsored by Inter IKEA Systems B.V. or any other brand mentioned. All product names and part numbers are used strictly for identification and compatibility purposes.

Step 1 of 3 · IKEA manual page 3

LISABO 140×78 step 1 of 3: Slide the legs into their slots

Lay the tabletop upside down on a rug. Under each corner is a slot: lower a leg’s ribbed end into its wide end, slide the leg along it towards the corner, and press it home. Do the same with the other three legs.

1× Tabletop
4× Leg

Tools: none, just your hands

All 3 steps

Parts and hardware checklist

1×	Tabletop	about 140×78×2.5 cm
4×	Leg	about 71×4.2×4.2 cm
4×	Wedge fitting	`#159426`
4×	Foot	`#153552`
1×	Key	`#105657`

Tools you need

Hammer · Not in the box: it taps the 4 plastic feet into the legs.

Questions

What tools do I need for the LISABO table?

A hammer, for the four plastic feet. The key (105657) that pushes the wedge fittings round comes in the box; the legs need no screws.

How are LISABO’s legs fixed?

Each leg’s ribbed end slides into a slot under a corner. A wedge fitting (159426) then drops into the slot behind it, and pushing the key down on the fitting’s toothed wheel wedges the leg tight.

Which way round does the wedge fitting go?

With its toothed wheel towards the leg. The manual crosses out a fitting turned the other way: its wheel then has nothing to grip and the leg stays loose.

A leg wobbles. What do I do?

Turn the table over and push the key down on that leg’s wedge fitting a few more times. If the fitting went in the wrong way round, lift it out and put it in with the wheel towards the leg.

Safety

From IKEA’s product page: for more stability, tighten the legs again when needed. The table is tested for general, non-domestic use (EN 15372) and is recommended for indoor use only.

About this guide

The steps, the part numbers, the counts and the order come from IKEA's assembly manual AA-1970558-4 (2018-01-05). The outer size, 140 × 78 × 74 cm, is IKEA's published size. The table’s length, width and height are IKEA’s; the top’s thickness, the legs’ sections and lean, and where the slots and fittings sit are read off the manual’s drawings, so they are close, not measured. The 3D runs faster than real hands do.

The manufacturer's instructions are on IKEA's product page (PDF). If something here differs from the manual in your box, follow the manual.

The 3D models, drawings and text are our own. IKEA and LISABO are named only to say which product this guide is for.