Step 3 of 3 · IKEA manual page 7
LINNMON / ADILS 100×60 step 3 of 3: Turn it over and level the feet
Turn the table over and stand it on its legs. If it rocks, turn the foot at the bottom of a leg to raise or lower it until all four stand on the floor. Tighten the screws again about two weeks later, and check them a couple of times a year.
Tools: none, just your hands
All 3 steps
Parts and hardware checklist
| 1× | Tabletop | about 100×60×3.4 cm |
| 4× | Leg | about 70.6×4×4 cm |
| 4× | Mounting plate | #104217 |
| 20× | Screw | #108443 · 4.5 × 25 mm |
Tools you need
- Cross-head screwdriver · Not in the box: the manual asks for one, for the 20 screws.
Questions
What tools do I need for the LINNMON / ADILS table?
A cross-head screwdriver for the 20 screws. The legs turn into their plates by hand.
Can I use a drill?
Turn the screws in with a hand screwdriver. A drill or impact driver can turn them on after they are tight, which strips the holes in the tabletop.
The table rocks. What do I do?
Turn the foot at the bottom of the short leg to lower it until all four legs stand on the floor.
How much weight does the tabletop hold?
IKEA gives a maximum load of 50 kg spread evenly over it, and no more than 15 kg in one spot.
Should I tighten the screws again?
Yes: the manual says to re-tighten them about two weeks after assembly, and to check them a couple of times a year.
Safety
From the manual: for more stability, tighten the screws again about two weeks after assembly, and check them a couple of times a year. IKEA says the table is made for home use and is not suited to a screen stand.
About this guide
The steps, the part numbers, the counts and the order come from IKEA's assembly manual AA-844478-7 (2026-02-05). The outer size, 100 × 60 × 74 cm, is IKEA's published size. The tabletop’s size and thickness and the legs’ height and width are IKEA’s, the screws’ size a spare-parts seller’s; the plates’ size and where they sit are read off the manual’s drawings, so they are close, not measured. The 3D runs faster than real hands do.
IKEA gives the tabletop a maximum load of 50 kg spread evenly, and no more than 15 kg in one spot.
The manufacturer's instructions are on IKEA's product page (PDF). If something here differs from the manual in your box, follow the manual.
The 3D models, drawings and text are our own. IKEA and LINNMON / ADILS are named only to say which product this guide is for.