iFlatpack.com is an independent platform creating original 3D procedural instructions. We are not affiliated with, endorsed by, or sponsored by Inter IKEA Systems B.V. or any other brand mentioned. All product names and part numbers are used strictly for identification and compatibility purposes.

Step 4 of 9 · IKEA manual page 7

STEFAN chair step 4 of 9: Stand the backrest in the side frame

Push 6 dowels into the backrest’s ends: 2 in each end of its top rail and 1 in each end of its bottom rail. Stand it in the holes up the back leg, where it leans back.

1× Backrest
6× Dowel 101350

Tools: none, just your hands

All 9 steps

Parts and hardware checklist

2×	Side frame	about 90×49.1×3.5 cm
1×	Back rail	about 30.9×7×2 cm
1×	Front rail	about 34.9×7×2 cm
1×	Backrest	about 34.1×30.3×2 cm
1×	Seat	about 42×37×1.8 cm
14×	Dowel	`#101350` · 8 × 30 mm
4×	Corner bracket	`#122620`
6×	Screw	`#104322`
4×	Screw	`#122925`
1×	Hex key	`#10083377`

Tools you need

Cross-head screwdriver · Not in the box: the manual asks for one, for the 4 screws that hold the seat.
Awl · Not in the box: the manual asks for one, to prick the seat’s 4 screw holes through the brackets.

Questions

What tools do I need for the STEFAN chair?

The hex key (10083377) in the box for the 6 long screws, a cross-head screwdriver for the 4 seat screws, and an awl to prick the seat’s screw holes. The manual also does the last steps on a table.

Which seat rail goes at the back?

The shorter one. The chair is narrower at the back than at the front, so the back rail is shorter than the front rail; the manual crosses out the long one at the back.

Why is the chair upside down on a table at the end?

The seat lies upside down on the table and the frame is lowered onto it, its backrest hanging over the edge, so you can line the seat up and screw it on through the corner brackets from above.

Should I tighten the screws again?

Yes: IKEA advises tightening them again about two weeks after assembly, and when needed after that.

Safety

From IKEA’s product page: for more stability, tighten the screws again about two weeks after assembly, and when needed. The chair is tested for home use (EN 12520 and EN 1022).

About this guide

The steps, the part numbers, the counts and the order come from IKEA's assembly manual AA-21977-11 (2021-03-24). The outer size, 42 × 49 × 90 cm, is IKEA's published size. The chair’s width, depth and height and the seat’s depth and height are IKEA’s; the parts’ sections, how much narrower the chair is at the back, the backrest’s lean and the table are read off the manual’s drawings, so they are close, not measured. The 3D runs faster than real hands do.

IKEA has tested the chair for a load of 110 kg (243 lb).

The manufacturer's instructions are on IKEA's product page (PDF). If something here differs from the manual in your box, follow the manual.

The 3D models, drawings and text are our own. IKEA and STEFAN are named only to say which product this guide is for.